page 32 of 68
• Reduce the transmission of vibration. Pre-
vent mechanical load due to rigid pipelines.
Insert elastic hoses or exible elements as
couplings between the pump and rigid pipes.
Note: Flexible elements will compress or
atten when evacuated if not designed for
use under vacuum.
• Hose connections at the pump inlet must al-
ways be gas tight.
In case, install a small ange connection KF
DN 16 (thread G1/8”) instead, see „Accesso-
ries“, pg. 44).
inlet
Use connecting hoses with large diameter and
keep them as short as possible to avoid ow
losses. Locate the pump as closely as possi-
ble to the application.
Secure hose connections at the pump ap-
propriately, e.g., with hose clamps, to protect
against accidental detachment.
NOTICENOTICE
✘
✔
+ Particles and dust must not be aspirated. If necessary,
you must install appropriate lters. You must ensure
their suitability concerning gas ow, chemical resis-
tance and resistance to clogging prior to use.
• A power failure may cause accidental ventilation of the
pump. If this constitutes a potential source of danger,
take appropriate safety measures.
Comments to this Manuals